Page 1 of 1

Tool Tip - 3D View for Underlay

Posted: Wed May 04, 2016 5:54 pm
by LisaSewBubbles
3D second.png
3D second.png (246.94 KiB) Viewed 2455 times
Should you adjust pull compensation of a Lettering object? Will shrinking or enlarging a design be successful? A lot depends on the underlay and you can see that by turning off the 3D. If a design has a “good foundation” you can usually enlarge it beyond the recommended safe 20% or make the letters fatter by increasing the pull compensation in the Stitches tab. A design with light or no underlay can usually be successfully shrunk beyond the recommended 20%. Analyzing your design provides you with knowledge to make informed decisions when customizing designs. The Itch 2 Stitch BX monogram font