excessive jumping?

Your questions answered here
Post Reply
Sheryl.R
Posts: 2
Joined: Fri Oct 26, 2018 12:51 pm

excessive jumping?

Post by Sheryl.R » Fri Oct 26, 2018 1:04 pm

i made a design using the magic wand that seemed to go really well, but it keeps jumping back and forth unnecessarily because it thinks it needs to draw the design from left to right, instead of in logical chunks. Am I missing something that will clean that up?

here's what i mean.

Full section:
Image

What it's doing:
Image

it also jumps around quite a bit in other sections!

Here's some examples of what it ends up looking like:
Image

thanks in advance, have a great weekend!

Sheryl.R
Posts: 2
Joined: Fri Oct 26, 2018 12:51 pm

Re: excessive jumping?

Post by Sheryl.R » Fri Oct 26, 2018 1:29 pm

or i guess it's just interpreting those straight sections as very long stitches? i'm not sure what i did wrong here.

Wilder
Posts: 57
Joined: Wed Nov 02, 2016 8:44 pm

Re: excessive jumping?

Post by Wilder » Fri Nov 02, 2018 6:04 am

Try adjusting your start and stop points. That can make a big difference. Currently they may both be on the same side of the design. Often times, it’s best if it starts on one side and stops at the opposite side.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests