Page 1 of 1

Project Advisor

Posted: Tue Aug 19, 2014 1:36 am
by bryben1212
I used the project advisor to change the density of a design I wanted to put on a t-shirt. I selected Knit, Medium weight. The design was originally a little over 21,000 stitches. The project advisor reduced it to roughly 15,995. When it stitched out, it was so sparce I could see the shirt under it. What could have gone wrong?

Re: Project Advisor

Posted: Tue Aug 19, 2014 4:45 pm
by EastWitch2
Hi bryben1212!

I would suggest you fill out a Support Ticket at the link below and ask the Support Team's help on this problem.
It does seem odd that you picked the Med. Knit setting and that the design ended up so much less dense after only using the Project Advisor.
Here is the direct link to the Support Ticket to fill in information.
http://embrilliance.com/contact-us

I was hoping Lisa would answer this here on the Forum so we could all learn more about the DRK program.! LOL

EastWitch2

Project Advisor

Posted: Thu Apr 07, 2016 2:29 am
by GeorgeSr
when I start doing the project 14 I have faced a problem, after I have wrote my codes therewas an error in the processing program say as the Pic .
so what I should do ?

Re: Project Advisor

Posted: Wed Apr 27, 2016 11:17 am
by Candy
I also would like to see the solution to this T shirt situation as I am still on the fence as to buyinging the DRK. I too would only be using the Project Advisor vs doing it manually. I lack the knowledge to do it myself.