Underlay stitches on fill keeps stitching in the same place

Your questions answered here
Post Reply
DawnW
Posts: 2
Joined: Wed Sep 23, 2015 3:23 pm

Underlay stitches on fill keeps stitching in the same place

Post by DawnW » Sun Jun 19, 2016 4:59 pm

I used the magic wand to create a fill space around an object (I'm making an applique Pokeball). When it stitches around the top half of the ball instead of just going around the circle it's like it wants to do the underlay in a vertical pattern. So it will stitch at the top and then do a running stitch to the middle, skip over a little way and do some more underlay. Then it will go back over to the side and do another running stitch back up to the top. It's done this so much that when the needle goes over that spot it actually lifts up the hoop. It's probably gone over the same spot about 50 times. Is there a way to change the way the underlay stitches out so it makes more sense?

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests