Digitizing Vector Letters

Your questions answered here
Joined:Sun Apr 28, 2019 10:22 am
Digitizing Vector Letters

Post by bokinser » Wed May 01, 2019 1:05 pm

I am very new and I'm reading and watching as much as I can. I am working on a logo that I have brought into the system as a vector. It is only 2 inches by 2.5. How do I digitize the words? The bean stitch leaves a gap and the satin stitch is completely unreadable? Any information is appreciated.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests